Just been setting up my Hermes to work with my desk mic.  <div><br></div><div>Audio works fine but PTT doesn't.<br><div><br></div><div>I have mic audio on the tip along with bias by setting JP4 linked 2-3 and JP5 also linked 2-3.<div>
<br><div>For the PTT line on the ring of the 3.5mm plug the user handbook says to link 1-3 of JP6, not only is this hard to do it is also wrong :-)</div><div><br></div><div>To use the PTT signal on the 3.5mm ring it should be linked 1-2 as verified by the schematic.</div>
<div><br></div><div>I have done this and noted that the PTT voltage goes from 3.3V to zero when keyed and measured at pin 1 of JP6 - as expected.</div></div><div><br></div><div>However the Hermes does not go into transmit mode - am I missing something here ?</div>
<div>I've checked the setup on PowerSDR but not found anything yet - the only way I can get it to TX is by using the keyboard space bar.</div><div><br></div><div>Any suggestions ?</div><div><br></div><div>Other than this minor problem - a brilliant piece work.</div>
<div><br></div><div>73 Tim KT6UK / G4WIM</div></div></div>