<div dir="ltr">I just completed my Penny Whistle build. Everything seemed to go together well. I ran the couple of tests in the manual, using the antenna tuner, since I had one, and then setting the trim pots. <div><br></div>
<div>Antenna VSWR looked good across all bands, about 1.1 - 1.3.<br><div><br></div><div>I wasn't pulling 20mA before adjusting the trim pots, more like 8mA. I didn't think it was a huge deal, I could be wrong? I adjusted the trimpots accordingly, bumping both up about 460mA. Voltage looked good, about 13volts. </div>
</div><div><br></div><div style>I can hit the bias control, and the current pull reads about 980mA, which is to be expected I'd think. When I transmist through it with the transceiver, it peaks to about 2.20 amps sometimes, once it warms up some.</div>
<div style><br></div><div style>I know I am getting out on the TX. I can hear myself on another rig on 40 meters running PSK. I assume it's RF from one antenna to another. But I don't hear anything. I thought it was just seriously attenuating the incoming RF, but I unplugged the coax from the output BNC, and the waterfall never changes. Just weak reception. If I plug the antenna coax back into the transceiver, the waterfall springs to life. I've tried swapping coax cables. I ran some continuity tests, and I get tone from BNC center on BNC input and output connector. But I also get tone from BNC center to BNC outer, which seemed odd, but some of the transformers seem make these connections?</div>
<div style><br></div><div style>Still searching for ideas, thought I would bounce it off the group. </div><div style><br></div><div style>Running an Ensemble RXTX, 20/30/40.</div><div style><br></div><div style>Thanks, </div>
<div style>Bryan</div><div style>K1TCP</div></div>