Hello All !<br><br>I finished my hombrew built of a Tapr Hermes board early sunday morning. <br><br>After a first power up, the board draws about 0,2 Ampere. (The Powermeter has no better resolution) All power supplies are ok and the relevant power leds are glowing. No lights on the staus leds.<br>
<br>I then tried to program the bootloader with active serial programming and an Entner EEBlaster (USB Blaster compatible). The power at P1 and P2 is there. I can program, erase, blank check and the Quartus Programmer reports the Silicon id as 0x14.<br>
<br>But nothing happend after a powercycle.<br><br>The same is valid for JTAG programming. I programmed the hermes.sof file succesfully to the board. the JTAG Chain debugger reports a user programmed FPGA.<br><br>I had it running two times from lets say about 50 tries. All status leds flashed like they should and i was able to read the config via the HPSDRProgrammer and also cuSDR was able to find the board. Power was about 0,6 Ampere then.<br>
<br>I had a problem using my stencil during the build and had some poor solder joints at the FPGA. I think i will go debug connection for connection and measure the relevant lines.<br><br>It seems, that the FPGA does not come out of his legs (has startup problems).<br>
<br>Any more suggestions. Otherwise i will debug the hardware tonight.<br><br>Many thanks in advance.<br><br>73 Oliver DL6KBG<br>