<div dir="ltr">You will not need a blaster even if the firmware load was not successful, please follow the following steps:<br><br>

<p class="">You will have to open the front panel of the radio in
order to force the Angelia card into bootloader mode:</p>

<p class="">1. Disconnect the Antenna/Power cable</p><p class="">2. Unscrew the front panel

</p><p class="">3. Remove the Power switch from the front panel Metal
head, there is a plastic lock (see disassembly guide refer user manual)

</p><p class="">4. Slide the bottom plate forward a few inches, locate
J17 and put a jumper on it

</p><p class="">5. Slide it back in and power the radio, the FPGA LED
should be flashing

</p><p class="">6. Download the HPSDR Programmer (1.6) from the Apache
web site (do not use a different version)

</p><p class="">7. Select Hermes and go into boot loader mode

</p><p class="">8. Program the board by pointing to the Angelia rbf file
(v2.0)

</p><p class="">9. Power off, remove j17, power on to check if the FPGA
LED is flashing, if it is you can reassemble the front panel </p><p class="">73s,</p><p class="">Abhi<br></p></div>