<div dir="ltr"><div>Hello All,</div><div><br></div><div>I've read the comments and questions on the Hermes Lite and tried to capture my responses below.</div><div><br></div><div>* The jumper on the FPGA board selects whether the FPGA board is powered through the 80-pin connector or USB. This jumpered signal does run to the daughter board and in the next versionn should be controlled by the daughter board. There is a github issue recorded for this.</div>
<div><br></div><div>* The prototype has extra jumpers to provide flexibility to try different things. The next version of the PCB can reduce the number of jumpers.</div><div><br></div><div>* The power output is theoretically 100 mW, and even 200 mW if you tolerate some distortion. If have tested up to 50 mW as shown in the WSPR spots. I couldn't go up to 100 mW because I did not have a binocular core of the right size on hand to get the proper turns ratio. Eventually, I'd like to see a small amp integrated to make this more like a RXTX Ensemble.</div>
<div><br></div><div>* I agree that this project is not ready for general use as it is. Only the bravest should attempt to build the current version! I put it out there to see what would happen. Who knows what others can and will do... I have tried to capture everything I can think of that needs to be fixed/improved in the online github project issues list.</div>
<div><br></div><div>* There are unused pins from the FPGA that connect to the unused PCIE-like connector. These can be repurposed to provide some I/O and control in a next version. </div><div><br></div><div>* Thanks to Rob, KL7NA, for keeping the demo going.</div>
<div><br></div><div>73,</div><div><br></div><div>Steve </div><div>KF7O</div><div><br></div></div>