<div dir="ltr">Yes, the Hermes-Lite should be usable as a VNA, although I have not tested this. Currently, it runs in half-duplex mode. I tried full-duplex but had some issues with noise at various front-end gain levels. I have asked ADI for help with this. You will have to use full-duplex for the VNA and the levels of noise I saw probably won't matter much for a VNA. Ideally, I'd like to see half-duplex for regular operation to keep the power consumption low, and then switch to full-duplex when needed for a VNA.<div>
<br></div><div>The design is now only 1 RX and 1 TX to keep the compile time down. The limitation yo will run into when compiling with 2 RX and 1 TX is not enough RAM resources. The Hermes had some large buffers because I believe it could. These will have to be reduced to fit 2 RX and 1 TX.</div>
<div><br></div><div>73, </div><div><br></div><div>Steve</div><div>KF7O</div><div><br></div></div>