<div dir="ltr">Dear All,<div><br></div><div> Yesterday I loaded my Hermes (TAPR) with V.2.9 firmware. I used the HPSDR bootloader for the process. The response of the bootloader was normal, asking to power recycle and remove the J12 jumper.</div>

<div><br></div><div>However after removing the jumper and recycling the power i found that  out of the two banks of the LEDs only one bank was glowing. </div><div><br></div><div>Status of LEDs is as follows: </div><div>a.     D23,D25,D26,D27,D28 are glowing red continously</div>

<div><br></div><div>b.     D10 - D18 LEDs not glowing </div><div><br></div><div>c.     D6 LED is also not glowing.</div><p class="">Now, the hermes bootloader is not detected. And strangely, if I retry to load the hermes firmware (.rbf) penelope is reported the program reports invalid rbf. </p>

<p class=""><br></p><p class="">Has anyone run into such a problem, any suggestions how can it be recovered ?? </p><p class=""><br></p><p class="">73,</p><p class="">Anupam </p><p class=""></p></div>