<div dir="ltr"><div>Several updates to the Hermes / Metis Gnuradio module.<br><br></div><div>These have been on GIT for awhile, just getting around to updating the TAPR SVN.<br></div><div>If you use Pybombs for Gnuradio, it points to GIT and will have the current gr-hpsdr code.<br>If you use TAPR SVN, these should bring the module current.<br>GIT is the master repository for gr-hpsdr:  <a href="https://github.com/Tom-McDermott/gr-hpsdr">https://github.com/Tom-McDermott/gr-hpsdr</a><br><br></div><div>1. If Verbose mode is turned on, it prints Pout and SWR about once a second to the console window.<br></div><div>    Thanks to Darren Long for this code.<br></div><div>2. The transmitter will now force 4 milliseconds of buffering by holding off sending samples for<br>    4 Ethernet frames, them sending them all as a burst to Hermes when Hermes Tx is started.<br>    This fills the Tx FIFO in the Hermes FPGA about 25% full. After the initial burst, samples<br>    are paced at the correct rate. This prevents an occasional underrun situation.<br><br>--  Tom, N5EG<br><br></div></div>