<div dir="ltr">Hi,<div><br></div><div>I am working on the Hermes-Lite V2 gigabit ethernet and have been reviewing the Hermes design. The current Hermes BOM specifies this rather expensive RJ45 jack:</div><div><br></div><div><a href="http://www.trpconnector.com/pdfs/6605444.pdf">http://www.trpconnector.com/pdfs/6605444.pdf</a><br></div><div><br></div><div>If you look at the schematic in that pdf, the center taps are shorted together via pin 1. This works for PHYs with current-mode transmit drivers, but is not recommended at gigabit speeds for voltage-mode transmit drivers as used in the KSZ9021. Although there is no discussion regarding this in the KSZ9021 datasheet, there is in the KSZ9031 datasheet. This may be why some people have trouble with gigabit speeds on the Hermes.</div><div><br></div><div>I'm using a different jack on the HL V2 that we've proven elsewhere, so do not face this problem, but wanted Hermes users to beware.</div><div><br></div><div>73,</div><div><br></div><div>Steve</div><div>KF7O</div><div><br></div></div>