<div dir="ltr"><div class="gmail_extra">OK, Mike, that's very good. I'd boil down your lengthy report as follows:</div><div class="gmail_extra"><br></div><div class="gmail_extra">- Layer 1 (physical) is 100% reliable.<br></div><div class="gmail_extra">- Layer 2 (data link) is not reliable with the GS724T.</div><div class="gmail_extra">- Layer 3 is 100% reliable if Layer 2 comes up OK.</div><div class="gmail_extra"><br></div><div class="gmail_extra">So now the question is: is this a problem that is unique to the GS724T, or is it unique to your specific radio?</div><div class="gmail_extra"><br></div><div class="gmail_extra">I can tell you that Layer 2 is 100% reliable with the 100D and 200D I have used here with both the Cisco and TP-Link managed switches.</div><div class="gmail_extra"><br></div><div class="gmail_extra">Are there any settings on the GS724T that might be relevant with respect to the specific port or MAC table dynamic entries? Perhaps you could try a different managed switch with the radio?</div><div class="gmail_extra"><br></div><div class="gmail_extra">73,</div><div class="gmail_extra"><br></div><div class="gmail_extra">Scott/w-u-2-o</div><div class="gmail_extra"><br></div><div class="gmail_extra"><br></div></div>