<div dir="ltr"><div>Jim,</div><div><br></div><div>Do you have Ethernet (wire or fiber) between the tower and the shack? If you do, I would suggest that the best way to do what you want is to fully virtualize your configuration by putting the radio at the tower and the PC in the shack and connect them by Ethernet. Then use VAC at the shack for transmit and receive, attach a PTT switch to a serial port on the PC, and attach a keyer to a serial port on the PC. Both such connections are fully supported by PowerSDR. If you have any RS-232 controlled devices that need to be with the radio, for instance a solid state amp like an Elecraft or SPE, then use a Moxa Nport device server to remote that back to your PC as well (the Moxa driver software is amazing--it makes it act just like a local serial device, no fuss, no muss).</div><div><br></div><div>If you use a nice audio interface at the PC that supports the ASIO driver (I use and highly recommend the Behringer UMC202HD) then, with judicious adjustment of the various buffer settings in PowerSDR and a reasonably fast PC, you can actually achieve latency over VAC that is LESS than that obtained with a mic and speaker attached to the radio. It helps to remember that all audio that is sourced at the radio itself must still flow from the radio over the Ethernet, be processed through PowerSDR, then be sent back to the radio over Ethernet, so the path for audio is somewhat lengthy. "Short circuiting" it at the PC using VAC can therefore actually save time given the right drivers and settings.</div><div><br></div><div>This is how I have my station setup and I use it every day like this.</div><div><br></div><div>As luck would have it, I am currently authoring a white paper on how to do most of the above in somewhat more detail. I should have it out in a few days.</div><div><br></div><div>73!</div><div><br></div><div>Scott/w-u-2-o</div><div><br></div><div><br></div><div>On Wed, Nov 16, 2016 at 6:30 PM, Jim Sanford <<a href="mailto:wb4gcs@wb4gcs.org">wb4gcs@wb4gcs.org</a>> wrote:</div><div>Scott:</div><div><br></div><div>I intend to mount my HPSDR out at the tower 350 feet away from the shack.  Have been working for a couple of years to figure out how to (affordably) get audio and PTT out there, as well as audio back. </div><div><br></div><div>Have stayed away from windows/VAC due to complaints I've seen about Windows latency; have been searching for some other VOIP way to do this.  (Good quality twisted pair audio cables were going to cost me $2K).</div><div><br></div><div>It appears that you know of a satisfactory way to do this on windows over ethernet.</div><div><br></div><div>Can you share any details or pointers beyond the product names??</div><div><br></div><div>Thanks & 73,</div><div><br></div><div>Jim</div><div><br></div><div><a href="mailto:wb4gcs@amsat.org">wb4gcs@amsat.org</a></div><div><br></div></div>