<div dir="ltr"><div>Hi Glen,</div><div><br></div><div>The problem you describe can happen when the external 10 MHz input reference to Hermes is not</div><div>actually toggling the logic.  This causes the Hermes FPGA to fall back into a mode where it senses</div><div>that it has no 10 MHz clock of any kind and thus uses one of the on-board oscillators to establish</div><div>10 MHz.  On my Hermes board when I tried an external reference is was off-frequency by just</div><div>about the amount you describe.</div><div><br></div><div>There is a known problem with the Hermes external reference clock input buffer.  I ended up having to</div><div>build a circuit to buffer that clock with a CMOS gate and bypass the two-transistor buffer on the board.</div><div><br></div><div>Dick, K9IVB did a design that provides auto-detection and switching.  I ordered some of his boards</div><div>from OSH Park, and built it up.  I did need to tweak one level on the board to get it to work properly,</div><div>but (it's been a couple years) it was just a resistor change or something similarly easy. Works great.</div><div><a href="http://www.k9ivb.net/Hermes/index.htm">http://www.k9ivb.net/Hermes/index.htm</a></div><div><br></div><div><br></div><div>-- Tom, N5EG</div><div><br></div><div><br></div></div>