<div dir="ltr">More details on the fuse problem are available here:<div><br></div><div><a href="https://apache-labs.com/community/viewtopic.php?f=17&t=2354&p=2381&hilit=fuse#p2381">https://apache-labs.com/community/viewtopic.php?f=17&t=2354&p=2381&hilit=fuse#p2381</a></div><div><br></div><div>73,</div><div><br></div><div>Scott/w-u-2-o</div><div><br><div class="gmail_extra"><br><div class="gmail_quote">On Thu, Apr 27, 2017 at 3:29 AM, Helmut <span dir="ltr"><<a href="mailto:dc6ny@gmx.de" target="_blank">dc6ny@gmx.de</a>></span> wrote:<br><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex">***** High Performance Software Defined Radio Discussion List *****<br>
<br>
Hi,<br>
<br>
I agree with Marvin that no hardware modification seems necessary. Running here Hermes from a 13.8V DC source, all onboard voltage regulators work fine and sufficiently 'cool'.<br>
RX and Tx functions seem ok after a quick test, but obviously DUP RX is still cancelled due to the lack of room in the FPGA. In my eyes DUP for real-time monitoring of the TX spectrum is indispensable. I repeat my suggestion to use the feedback RX of Pure Signal for this purpose.<br>
<br>
Thanks guys in advance.<br>
<br>
73, Helmut, DC6NY<br>
<br>
<br>
-----Ursprüngliche Nachricht-----<br>
Von: Hpsdr [mailto:<a href="mailto:hpsdr-bounces@lists.openhpsdr.org">hpsdr-bounces@lists.<wbr>openhpsdr.org</a>] Im Auftrag von John Marvin<br>
Gesendet: Donnerstag, 27. April 2017 06:51<br>
An: <a href="mailto:hpsdr@lists.openhpsdr.org">hpsdr@lists.openhpsdr.org</a><br>
Betreff: Re: [hpsdr] protocol 2 for Hermes<br>
<br>
***** High Performance Software Defined Radio Discussion List *****<br>
<br>
Note that as far as the power supply issue is concerned regarding the<br>
original Hermes, I don't think there is any hardware change that needs<br>
to be made to the board itself. It's a matter of setting the right<br>
jumpers and providing an external supply capable of delivering both a<br>
regulated 12V supply and a regulated 5V supply. The details regarding<br>
this can be found in the Hermes manual.  So no SMD soldering is<br>
required, but some external hardware changes will need to be made, the<br>
difficulty of which will depend on your current power supply and the<br>
case you are currently using.<br>
<br>
It does sound like owners of original Hermes boards would need to do<br>
some soldering to replace the resettable fuses. I'd certainly like more<br>
details regarding that, since my primary transceiver is based on a TAPR<br>
produced Hermes board and I would like to be able to run multiple<br>
receiver slices at maximum sample rates, which would require the use of<br>
1Gbit networking.<br>
<br>
Regards,<br>
<br>
John<br>
AC0ZG<br>
<br></blockquote></div></div></div></div>