<div dir="ltr">Hi List,<div><br></div><div>I saw discussion regarding using a Zedboard or SOM for the FPGA side of a Hermes redesign. This is a good idea and one we discussed for the Hermes-Lite 2 redesign almost a year ago. Since our goal was low cost, the best option we found was the Z-Turn from Myirtech:</div><div><br></div><div><a href="http://www.myirtech.com/list.asp?id=502">http://www.myirtech.com/list.asp?id=502</a><br></div><div><br></div><div>There are two sizes: 28K for $99 and 85K for $119. </div><div><br></div><div>I looked closely at the schematics for the Z-turn board and am impressed that they attempt to properly route LVDS pairs. The connectors used on the Z-Turn are also more commonly available and less expensive (compared to microzed) but should still handle speeds required. </div><div><br></div><div>I have done designs at my day job with with Microzed. They also work well but are higher price. The new Ultrazed based on a new ultrascale+ part has a more advanced ARM core embedded and may be of interest.</div><div><br></div><div>Ultimately we went with the Cyclone IV on our own Hermes-Lite 2 board as the total unit cost was lower, but that may not be as important for a Hermes redesign.</div><div><br></div><div>If openhpsdr is considering a design which separates the FPGA from the RF, then people should take a close look at the R2T2 SDR:</div><div><br></div><div><a href="http://r2t2.de/index.php?title=Hauptseite">http://r2t2.de/index.php?title=Hauptseite</a><br></div><div><br></div><div>They are already doing this. They have quite a few radios online:</div><div><br></div><div><a href="http://napan.com/qtradio/qtradio.pl">http://napan.com/qtradio/qtradio.pl</a><br></div><div><br></div><div>73,</div><div><br></div><div>Steve</div><div>KF7O</div><div><br></div><div><br></div><div><br></div><div><br></div><div><br></div></div>