<div dir="ltr"><div><div><div><div><div><div><div><div><div><div><div><div><div><div><div><div><div><div>Hi Jim - using the version 3.1  (the 'old' protocol) on my Hermes it retrieves a DHCP address<br></div>automatically.   It used to be that switches and routers would not remember which<br></div>devices used which addresses, meaning that any particular device on your home LAN<br></div>could change IP addresses when power cycled.  this was a real pain when opening</div><div>firewall ports for example.</div><div><br></div>However modern Ethernet switches and routers usually now have a 'reservations'<br></div>table that auto populates.  It remembers which MAC devices got which IP address<br></div>in the past, and it makes sure to re-assign that exact same IP address to that same device</div><div> in the future.     So for most common cases I can think of, the use of static IP is really</div><div> not needed anymore.<br></div><br></div>Ethernet added an MDI-X PHY type for 100Meg and 1Gig awhile ago.  For devices made in<br></div>the last few years, they will automatically auto-crossover if needed.   The Ethernet<br></div>interface in your computer may or may not have the capability, but I suspect that your<br></div>Ethernet switch or router does.   That's why when you hook Hermes to that more modern<br></div>switch or router, it will detect the configuration and auto-crossover if it is needed.<br><br></div>So if you connect two old computers at 100M you might need a crossover cable, but<br></div>if they are recent or you have a switch or router in the path, it should automatically work.<br></div>1G Ethernet usually always does the MDI-X function.  That's because 1GE uses all 4<br></div>pairs in the cable at the same time.  In fact all 4 pairs are operating full-duplex, 1GE sends<br></div>lane identifier information down each pair so the receiver can figure out what's going on.<br><br></div>-- Tom, N5EG<br><br><div><div><div><div><div><div><div><div><div><div><div><br></div></div></div></div></div></div></div></div></div></div></div></div>