<div dir="ltr"><div dir="ltr">Luke,<div><br></div><div>See here for more information about PureSignal feedback levels:</div><div><br></div><div><a href="https://apache-labs.com/community/viewtopic.php?f=20&t=2384">https://apache-labs.com/community/viewtopic.php?f=20&t=2384</a></div><div><br></div><div>You can certainly switch coupling methods when operating at 100W and below, and I noted that in my email. However that requires one to change settings, and having to change things takes time and can lead to mistakes. It would all be so much simpler if Elecraft chose to provide a 50dB coupling factor.</div><div><br></div><div>On early serial number 200Ds you would have to rely on crosstalk, which will provide less than optimal results. If it is a later serial number unit with the Rev. 24 RF board you will actually be relying on an internal coupled path, so it's a "legit" solution.</div><div><br></div><div>Linearization works in all modes. On CW you have to use the non-automatic "single cal" mode using the two tone test signal to set it up, and its benefits are minimal.</div><div><br></div><div>73,</div><div><br></div><div>Scott/w-u-2-o</div><div><br></div><div><br><div class="gmail_quote"><div dir="ltr">On Sun, Sep 9, 2018 at 6:00 AM List Mail <<a href="mailto:mail10@barefoothorse.com.au">mail10@barefoothorse.com.au</a>> wrote:<br></div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex">
<div dir="ltr">
<div dir="ltr">
<div style="font-size:12pt;font-family:Calibri;color:rgb(0,0,0)">
<div>Scott,</div>
<div> </div>
<div>In the SPE 1.5kFA, there is a 60 dB coupler provided for pre-distortion. I 
am using an ANAN-200D transceiver. I have not yet connected the pre-distortion 
cable.</div>
<div> </div>
<div>Please clarify for me; </div>
<div>“It is most unfortunate that Hilberling chose to use a 60dB coupling 
factor. This does, of course, result in a coupled output level of 0dBm at 1KW 
(60dBm). With that configuration, the PureSignal linearization function becomes 
unusable on the ANAN-7000 and -8000 below approx. 100W, which is the point at 
which the step attenuator on the receive path reaches the bottom limit its 
dynamic range, i.e. 0dB attenuation.”</div>
<div> </div>
<div>If I am going to be using <100 watts, I will not be using the PA. I 
understand there is sufficient cross-talk within the transceiver to enable the 
functioning of Pure Signal. With insufficient feedback coming from the coupler 
at the output of the PA, will Pure Signal still function with the internal 
cross-talk in the transceiver?</div>
<div> </div>
<div>I almost exclusively use CW, does Pure Signal even function in this 
mode?</div>
<div> </div>
<div>73,</div>
<div> </div>
<div>Luke VK3HJ</div></div></div></div>
</blockquote></div></div></div></div>