<div dir="ltr"><div>Assuming it is not a proverbial "dumb mistake", and it doesn't sound like it is because you have more than one board and, if you swapped out one board with another and the second board works in that position, then it certainly sounds like a hardware failure of some kind. </div><div><br></div><div>Do the LEDs on the connector indicate a good connection with traffic? If so, then the problem is probably between the PHY and the FPGA. Unless you have an x-ray machine you can't see under the FPGA, which leaves the PHY connections the only thing you can inspect. Do you have something with high enough magnification to do that with?</div><div><br></div><div>If it's a bare board you might also have damaged something via ESD.</div><div><br></div><div>Again, assuming you swapped another board into the same position that your problem board is in and it worked, the only other thing I can think of is to reprogram a second board and see if you have a problem with your programming setup.</div><div><br></div><div>73,</div><div><br></div><div>Scott<br></div><div><br></div><div class="gmail_quote"></div></div>