<div dir="ltr"><div dir="ltr">Is this Protocol 1 or 2? If Protocol 2, is the NUC capable of Gigabit Ethernet on the wired port?</div><div dir="ltr"><br></div><div dir="ltr">Are you using APIPA? If so, then the subnet mask on the PC must be 255.255.0.0 and the SDR board must be set to DHCP (0.0.0.0).<div><br></div><div>Static addressing is greatly preferred over APIPA for direct connections. I recommend static addressing for direct connections. If you are using WiFi on the NUC choose a different subnet for the wired port and SDR board. E.g. if the WiFi is 192.168.1.x then use 192.168.5.x on the wired port and SDR board. Subnet mask 255.255.255.0.<br><div><br></div><div>If the NUC has WiFi enabled this counts as a second NIC and the Network Metric settings must be manually set so that the wired port has a lower Network Metric value than the WiFi adapter. Otherwise disable the WiFi.</div><div><br></div><div>73,</div><div><br></div><div>Scott<br><div><br></div></div></div></div><br><div class="gmail_quote"><div dir="ltr" class="gmail_attr">On Thu, May 30, 2019 at 9:48 AM Kjell Karlsen <<a href="mailto:la2ni@online.no">la2ni@online.no</a>> wrote:<br></div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex"><br>
Hi All.<br>
<br>
For the first time as far as I can remember, I am not able to get in  <br>
direct connection from a PC to an Orion MKII (and Hermes)<br>
<br>
I am using an Intel NUC Mini PC with a i7 processor. It work perfect as  <br>
long as the LAN connection is via a switch but when trying direct  <br>
connection, it does not work. The strange thing is that if they have been  <br>
connected and I just move the cable from the switch and connect directly,  <br>
the connection is OK for around 10-20 seconds, then disconnects and after  <br>
that it is not possible to connect.<br>
<br>
I have had times before that I had to set a fixed IP address on the  <br>
OpenHPSDR card to use direct connection and then there was no problem. And  <br>
I have tried on 2-3 other PC´s, all with Win10 installed and it always  <br>
works.<br>
<br>
So I have concluded that there must be a setting in the NUC PC that is  <br>
different from the others. I had problems when I first  installed Win10 on  <br>
that PC. I had to select UEFI instead of Legacy when booting during setup  <br>
(whatever this means, I am not a PC Guru anyway!)<br>
<br>
Can someone lead me in the right direction?<br>
<br>
73, Kjell<br><br></blockquote></div></div>