<div dir="ltr"><div>The problem would appear that you think your radio is the box you bought from Apache Labs. That box is only 20%, give or take, of the radio. 80% of the radio is the software that runs on your PC. Together they make a complete radio.</div><div><br></div><div>Your PC certainly has USB ports, and that is where you plug in the micro Keyer. No virtual ports are required. When you plug in the micro Keyer it presents several physical COM ports over that USB interface to the PC. You then go into PowerSDR (or Thetis, if you are using that) setup and assign the correct ports to the correct functions (CW key, CAT, etc.)</div><div><br></div><div>Similarly, the micro Keyer will present an audio device to the PC over the USB interface. That device is what you assign in PowerSDR VAC setup so that audio can flow between the micro Keyer and PowerSDR.</div><div><br></div><div>73,</div><div><br></div><div>Scott/w-u-2-o</div><br><div class="gmail_quote"><div dir="ltr" class="gmail_attr">On Fri, May 1, 2020 at 11:20 AM Rafael Meneses Mendoza <<a href="mailto:ea8csd.radio@gmail.com">ea8csd.radio@gmail.com</a>> wrote:Y<br></div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex"><div dir="ltr">Good afternoon.<br>I am trying to configure a micro Keyer III with my anan 100d, I have created a virtual port I have configured and I see that it recognizes that the port is open (open 38400 8N1) but I cannot establish the reading of the equipment.<br>In CAT Control I have selected the ID as: TS-2000.<br>What else can I do since the radio doesn't have rs-232?<div><br>Thank you<br></div><div><br></div><div>Rafael EA8TK</div></div></blockquote></div></div>