[hpsdr] Come and get it, code's ready!

[hartfuss]

Hi Bill, Phil, Kirk,
just updated Penelope and Mercury successfully within a few minutes. It 
works fine with the KD5TFD May 28 version of PowerSDR (even with the old 
mdb-file). Previously occasionally occuring short dropouts are gone. Great!
Thanks and best 73s, Hans, DL2MDQ.




Bill Tracey schrieb:

> ***** High Performance Software Defined Radio Discussion List *****
> 
> All,
> 
> Thanks to the great work done by Kirk KD7IRS we have new version of FPGA 
> code for all the HPSDR boards.  The latest versions completely removes 
> any remnants of board position sensitivity and should also allow 
> operation at 192k/2048k on PC's that previously had difficulty with 
> these rates.
> 
> The new code also improves the performance using John Melton's GTK+ 
> Linux console -
> 
> < http://javaguifordttsp.blogspot.com/ >.
> 
> It is also essential for use with the shortly to be released Windows 
> K.I.S.S. Konsole.
> 
> In order to make use of this new code the ROMs on Penny and Mercury 
> boards must be updated. If you're using Janus with Mercury and/or 
> Penelope you will need to update it as well.   A new version of PowerSDR 
> that has the new Ozy and FX2 code has been posted.
> 
> The latest version numbers are:
> 
> Mercury - V2.7
> Penelope - V1.2
> Janus - V3
> Ozy - V1.3
> FX2 -  20090524
> 
> The procedure to update the CPLD or EEPROMs on the various boards is the 
> same as before.  Use SVN to check out the files from
> 
> < svn://206.216.146.154/svn/repos_sdr_hpsdr/trunk/USBBlaster-Binaries >
> 
> and follow the instructions in the README.txt file.
> 
> You must also use the latest Ozy_Janus.rbf, ozyfw_sdr1k.hex and  
> PowerSDR files which can be obtained from the usual SVN place:
> 
> < 
> svn://206.216.146.154/svn/repos_sdr_windows/PowerSDR/branches/kd5tfd/PennyMerge/bin/Release 
>  >
> 
> At this time Janus is only working well at 192khz, so PowerSDR is 
> currently setup to use the prior version of Ozy and FX2 firmware when 
> configured for an SDR 1000 + Janus setup.  If that's you're 
> configuration it is not recommended to update the Janus CPLD code at 
> this time
> 
> As before please report any successes or problems via the HPSDR mail 
> reflector.
> 
> 
> Phil (VK6APH)
> Bill (kd5tfd)
> 
> _______________________________________________
> HPSDR Discussion List
> To post msg: hpsdr at openhpsdr.org
> Subscription help: 
> http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
> HPSDR web page: http://openhpsdr.org
> Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/
> 
> .
> 


 1243615976.0