[hpsdr] Janus Alpha Construction - oscillator to match the pads

[Bill Tracey]

Also looks like Mouser: 581-K50-3C0SE24.57M  will fit the bill here as well 
-- and cheaper than the Digikey below.

Bill

At 12:53 AM 6/8/2006, Bill Tracey wrote:
>***** High Performance Software Defined Radio Discussion List *****
>
>Lyle -- Are the dimensions of the pads on the gerbers correct -- I get them
>as:
>
>Outer Edge to Outer Edge: 6.35 x 7.06
>Center to Center:   4.30 x 5.06
>Inner Edge to Inner Edge:  2.02 x 3.11
>
>X x Y in mm
>
>To me it looks like DIgikey: CTX326LVCT-ND  might fit the pads.
>
>Regards,
>
>Bill
>
> >2) The PCB footprint for the oscillator is too large.  It is possible to
> >fit the oscillator by first putting blobs of solder on its four pads,
> >then pre-tinning the four PCB pads, then carefully placing and
> >soldering.  We should find a different oscillator (to match the PCB)
> >and/or change the PCB layout in the next round.
>
>
>_______________________________________________
>HPSDR Discussion List
>To post msg: hpsdr at hpsdr.org
>Subscription help: http://lists.hpsdr.org/listinfo.cgi/hpsdr-hpsdr.org
>HPSDR web page: http://hpsdr.org
>Archives: http://lists.hpsdr.org/pipermail/hpsdr-hpsdr.org/



 1149747253.0