[hpsdr] JANUS and OZY

[Alex]

Well since Horst brought it up again   : )

The proposal I made (http://www.hamsdr.com/personaldirectory.aspx?id=245) is smaller in size than the filter board on the SDR-1000. And the mounting bracket is optional. Plus the proposed external connector location will allow you to mechanically stack the OZY, JANUS and ATLAS close to the SDR-1000 stack without interfering with each other.

Folks, I've looked at this for a while, I haven't just thrown it out there without a couple of good reasons. Run the numbers yourself.

Alex, N3NP

----- Original Message ----
From: H. Gruchow <horst at needles.de>
To: hpsdr at hpsdr.org
Sent: Monday, May 22, 2006 12:04:28 PM
Subject: [hpsdr] JANUS and OZY

***** High Performance Software Defined Radio Discussion List *****

Hi folks,

whowwwww, what an enthusiasm I could notice on the list that Phil and Lyle have finished 
the board design of OZY and JANUS!!!!!!

Therefore from my side:

Bravooooooo, well done. Outstanding work. Fantastic job both of you have done on the 
schematics as well as on the PCB layouts.

Congratulations to both of you as well as to Phil H. and all the others within the 
development teams.

When the prototyping of the boards is planned? I hope soon.


Regarding changing the form factor of ATLAS and all boards I would say: leave it for now 
as it is. I would like it as small as possible.

Stacking up two boards if you only need two seems to be easy. Mount a straight female DIN 
connector on the JANUS and a straight male connector on the backside of OZY (I think this 
gives a nice sandwich).


73
Horst
DL6KBF

_______________________________________________
HPSDR Discussion List
To post msg: hpsdr at hpsdr.org
Subscription help: http://lists.hpsdr.org/listinfo.cgi/hpsdr-hpsdr.org
HPSDR web page: http://hpsdr.org
Archives: http://lists.hpsdr.org/pipermail/hpsdr-hpsdr.org/




 1148316266.0