[hpsdr] Pinocchio Updated

[Steven Bible]

Lyle,

What is the part number of the test points you are using?

73,

- Steve, N7HPR
 (n7hpr at tapr.org)
 

> -----Original Message-----
> From: hpsdr-bounces at hpsdr.org [mailto:hpsdr-bounces at hpsdr.org]On Behalf
> Of Lyle Johnson
> Sent: Saturday, May 27, 2006 10:51 AM
> To: High Performance Software Defined Radio Discussion List
> Subject: [hpsdr] Pinocchio Updated
> 
> 
> ***** High Performance Software Defined Radio Discussion List *****
> 
> I modified the PCB layout to accommodate the difference spacing for the 
> mounting holes as pointed out by Leon.
> 
> I note that the pin 1 and pin 32 ends match for the male and female 
> parts, which seems a bit strange.  If you mate right angle connectors, 
> as I do on Pinocchio, then one of the connectors will be labeled 
> backwards.  I labeled the pins on the silkscreen to match ATLAS in a 
> "flow through" fashion, so the female connector used at "J1" at the top 
> of the PCB will have a mismatch between the connector marking and the 
> PCB marking..
> 
> I also added the obligatory copyright stuff.
> 
> I updated the wiki to point to the correct files.
> 
> 73,
> 
> Lyle KK7P
> 
> _______________________________________________
> HPSDR Discussion List
> To post msg: hpsdr at hpsdr.org
> Subscription help: http://lists.hpsdr.org/listinfo.cgi/hpsdr-hpsdr.org
> HPSDR web page: http://hpsdr.org
> Archives: http://lists.hpsdr.org/pipermail/hpsdr-hpsdr.org/

 1148853682.0