[hpsdr] Janus Beta Rev XC8

[Lyle Johnson]

Eric Ellison wrote:
> Hi Guys!
> 
> I saw this too on the Alpha Atlas. I think if you look at the coordinates it
> is balking at an overlap of the connector. I could be wrong also.

These crop up from time to time. I just ignore them.  Worst case, the 
resist gets blasted with the laser twice.

Lyle
> 
> Eric
> 
> 
> -----Original Message-----
> From: hpsdr-bounces at hpsdr.org [mailto:hpsdr-bounces at hpsdr.org] On Behalf Of
> Lyle Johnson
> Sent: Sunday, September 24, 2006 11:44 AM
> To: Christopher T. Day
> Cc: High Performance Software Defined Radio Discussion List
> Subject: Re: [hpsdr] Janus Beta Rev XC8
> 
> ***** High Performance Software Defined Radio Discussion List *****
> 
> Hello Chris!
> 
>> As I find them...
>>
>> 1) ViewMate reports "---WARNING--- Zero length draw detected at (4.06
>> 3.16). Convert to pad?" for Janus.gnd.
>>
>> 2) ViewMate reports "---WARNING--- Zero length draw detected at (4.06
>> 3.16). Convert to pad?" for Janus.pwr.
>>
>> 3) ViewMate reports "---WARNING--- Zero length draw detected at (3.82
>> -0.03). Convert to pad?" for Janus.sst.
>>
>> I said "Yes" to all of these.
> 
> QSL
> 
> These are apparently database artifacts.  There is nothing in the design 
> file I can find on these layers.  I often get a small number of these on 
> designs and just ignore them.
> 
> I really need to switch to a later version of OrCAD Layout, which I have 
> but have been too lazy to switch over to.
> 
> Thanks for noticing this!
> 
> 73,
> 
> Lyle KK7P
> 
> _______________________________________________
> HPSDR Discussion List
> To post msg: hpsdr at hpsdr.org
> Subscription help: http://lists.hpsdr.org/listinfo.cgi/hpsdr-hpsdr.org
> HPSDR web page: http://hpsdr.org
> Archives: http://lists.hpsdr.org/pipermail/hpsdr-hpsdr.org/
> 
> 
> 



 1159121305.0