[hpsdr] Janus/Ozy with SDR1000 almost working

[Jerry Flanders]

After trying several things suggested by others, I think my USB 
communication PC to/from Janozy is working now.

      I can run initozy.bat without errors.

      After I run initozy.bat, the correct group of LEDs 
light/alternate on the board.

      PowerSDR 1.9.1 Beta (from flex-radio site) seems to inter-act 
with the SDR1000 (i.e., turning SDR1000 power on/off makes PowerSDR 
panadaptor background level bounce up/down and audio output changes a 
little. Also, there is a panadaptor hump about 30 dB above background 
about 9 kHz below the "tuned" freq.

HOWEVER, PowerSDR finds NO signals - Zilch. Not even my Elecraft xg2.

The SDR1000 is still working OK, because I restored it to the Delta44 
card and signals were there again (phew!).

I then reconnected the SDR1000 to the Janozy boards and wiped out the 
PowerSDR MDB file and re-built it properly, BUT STILL NO SIGNALS - 
same old hump down 9 kHz, etc.

Anyone have ideas to share? I would appreciate hearing them. Since I 
have USB communications and I can initialize Janozy, I assume my 
initozy.bat and libusb stuff are AOK.

Jerry W4UK


 1187023614.0