[hpsdr] Janus/Ozy with SDR1000 IS WORKING

[Jerry Flanders]

Update:

After installing Tortoise and using it to get the complete new 
package of JanOzy - optimized PowerSDR V1.63, my Janus/Ozy/SDR1000 
radio is ALIVE. I hear signals!

Now to optimize and then see if I can get V1.9.1 working.

Thanks for all the help, guys.

Jerry W4UK

At 12:46 PM 8/13/2007, Jerry Flanders wrote:
>***** High Performance Software Defined Radio Discussion List *****
>
>After trying several things suggested by others, I think my USB
>communication PC to/from Janozy is working now.
>
>       I can run initozy.bat without errors.
>
>       After I run initozy.bat, the correct group of LEDs
>light/alternate on the board.
>
>       PowerSDR 1.9.1 Beta (from flex-radio site) seems to inter-act
>with the SDR1000 (i.e., turning SDR1000 power on/off makes PowerSDR
>panadaptor background level bounce up/down and audio output changes a
>little. Also, there is a panadaptor hump about 30 dB above background
>about 9 kHz below the "tuned" freq.
>
>HOWEVER, PowerSDR finds NO signals - Zilch. Not even my Elecraft xg2.
>
>The SDR1000 is still working OK, because I restored it to the Delta44
>card and signals were there again (phew!).
>
>I then reconnected the SDR1000 to the Janozy boards and wiped out the
>PowerSDR MDB file and re-built it properly, BUT STILL NO SIGNALS -
>same old hump down 9 kHz, etc.
>
>Anyone have ideas to share? I would appreciate hearing them. Since I
>have USB communications and I can initialize Janozy, I assume my
>initozy.bat and libusb stuff are AOK.
>
>Jerry W4UK


 1187034033.0