[hpsdr] Problems bringing up Janus/Ozy

[Bill Tracey]

Steve - I don't recall if this ever got answered or not.

There is one known issue where load_firmware or some of the other 
utils will fault as they exit  -- this appears to be a benign failure 
as things seem to work fine.

Ignoring the found new hardware can be problematic -- if no driver is 
assigned to Ozy then everything  in initozy.bat will fail since it 
will be unable to find the device.

Can you look with device manager (control panel, system, hardware, 
device manager) and see if the Ozy is listed after you plug it in -- 
it shows up under a section libusb devices or something like that.

Regards,

Bill (kd5tfd)

At 08:17 PM 7/1/2007, Steven Wilson wrote:
>***** High Performance Software Defined Radio Discussion List *****
>
>Did this ever get an answer?  I'm seeing exactly the same error.
>
>Steve KA6S
>
>David Woodhead wrote:
> > ***** High Performance Software Defined Radio Discussion List *****
> >
> > My PC is a Del P4 2.8GHz 512MB RAM
> >
> > I loaded the USB driver per the documentation - no problem
> >
> > When I run Intozy.bat I get the following error message:
> >
> > the instruction at 0x7C92ae17 referenced memory at 0x00c2fff0. 
> The memory couldnot be read. Click OK to terminate.
> >
> > Also, the found new hardware wizard opens (which ignore since I 
> already loaded the USB driver)
> >
> > after clicking OK I get 7 sucessive messages (windows) saying 
> write I2C has encountered a problem. Finally the DOS window stays 
> open waiting for me to press a key.
> >
> > The OZY board LED's are flashing as they should. When I run Power 
> SDR I can not select the Janus/ozy control check box (it does not respond).
> >
> > What is wrong?
> >
> > Thanks!
> >
> > David.



 1183349840.0