[hpsdr] update from VU3RDD

[Roland ETIENNE]

Hi Ramakrishnan,

Congratulations for having complete, and working, assembly of Janus-Ozy 
cards! These are really wonderful hardware, I am using them with the 
SDR1000 every day, and I cannot imagine going back to other sound card.

Have fun,

73, Roland f8chk.

Ramakrishnan Muthukrishnan a écrit :
> ***** High Performance Software Defined Radio Discussion List *****
>
> Hi,
>
> got my pre-assembled Janus this friday evening. Hooked it up with my
> Ozy on Atlas. During initozy11.bat, I saw those i2c errors again. On a
> closer study of Ozy schematics, I found that I had missed out those
> zero ohm resistor jumpers. Fixed all of them according to the
> peoduction setup as detailed by Scotty in an earlier email to the
> group. Now everything see to be fine, initozy went fine without any
> errors. Once FPGA was loaded, the two Janus LEDs in the centre went
> off. I fired up the svn ocopy of powerSDR and configured it to use Ozy
> control and sound card as Janus. Things seem to be fine. I see a noise
> floor down much under -140 dBm with a small spike at the center
> frequency. Yet to calibrate the powerSDR (this is the first time I am
> using it..). I do not have an RF frontend at the moment, as my older
> softrock receivers are with other friends. I am now building a
> Softrock RXTX v6.2 to hook up with the A/J/O.
>
> Will report back with more results once softrock is up.
>
> 73
> Ramakrishnan, VU3RDD
> _______________________________________________
> HPSDR Discussion List
> To post msg: hpsdr at hpsdr.org
> Subscription help: http://lists.hpsdr.org/listinfo.cgi/hpsdr-hpsdr.org
> HPSDR web page: http://hpsdr.org
> Archives: http://lists.hpsdr.org/pipermail/hpsdr-hpsdr.org/
>
>
>   


 1185698480.0