[hpsdr] ADC for VSWR Measurement

[Phil Harman]

Hi Gerd,

If it  is already a digital signal at say 0-3v then you could connect it 
directly to a spare pin(s) on the Atlas bus. The currently used pins are in 
SVN under

/trunk/Atlas/Atlas to Janus V2 - OzyV2-Penelope Interface.xls.

It they are analogue signals then you could use some of the spare four ADC 
inputs on Penelope at either P4 or J6.

The Forward and Reflected power signals from the Alex LPF filter board will 
be available on the ribbon connector that connects Alex  to Mercury. From 
Mercury you will be able to jumper across to Penelope to pick up the ADC and 
hence monitor Fwd/Ref volts and then calculate  Power out, Z,  SWR etc on 
the PC. With 100w out of Alex  the log corrected directional coupler will 
read down to 100mW. This can be set lower if you want to run your PA below 
the 100w level.

73's Phil....VK6APH




----- Original Message ----- 
From: "Gerd Loch" <g.loch at nt-electronics.de>
To: <hpsdr at hpsdr.org>
Sent: Saturday, August 23, 2008 5:35 AM
Subject: [hpsdr] ADC for VSWR Measurement


> ***** High Performance Software Defined Radio Discussion List *****
>
> Where can one connect the Dout of the ADC (VSWR of a PA) to in the HPSDR
> hardware ?
>
> 73, Gerd
> DJ8AY
>
> _______________________________________________
> HPSDR Discussion List
> To post msg: hpsdr at hpsdr.org
> Subscription help: http://lists.hpsdr.org/listinfo.cgi/hpsdr-hpsdr.org
> HPSDR web page: http://hpsdr.org
> Archives: http://lists.hpsdr.org/pipermail/hpsdr-hpsdr.org/
>
> No virus found in this incoming message.
> Checked by AVG - http://www.avg.com
> Version: 8.0.138 / Virus Database: 270.6.7/1628 - Release Date: 8/22/2008 
> 6:32 PM
>
>
> 


 1219490190.0