[hpsdr] ADC for VSWR Measurement

[Phil Harman]

Hi Gerd,

The connections you suggest are correct. The 4 spare analogue inputs on 
Penelope are there for exactly this reason but the code is not yet written. 
You will see the code is already there for the ALC on Penelope so you could 
use this as a starting point.

73's Phil...VK6APH


----- Original Message ----- 
From: "Gerd Loch" <g.loch at nt-electronics.de>
To: <hpsdr at hpsdr.org>
Sent: Tuesday, August 26, 2008 5:04 PM
Subject: [hpsdr] ADC for VSWR Measurement


> ***** High Performance Software Defined Radio Discussion List *****
>
> may I ask again?
>
> I found the analog signals (FWD, REFL) going to Mercury J6 and then to a 4
> pole connector J3.
> I suppose that a cable should connect from J3 on mercury to to J6 or P4 on
> Penelope. (my basis is schematic XA9 for Mercury) Is this the correct 
> path?
> There are 4 analog inputs AIN1-AIN4 on Penelope. What are they provided 
> for?
> Is the analog feedback already integrated in the software for Penelope? If
> yes for which of the four AINs?
>
> 73, Gerd DJ8AY
>
>
>
> _______________________________________________
> HPSDR Discussion List
> To post msg: hpsdr at hpsdr.org
> Subscription help: http://lists.hpsdr.org/listinfo.cgi/hpsdr-hpsdr.org
> HPSDR web page: http://hpsdr.org
> Archives: http://lists.hpsdr.org/pipermail/hpsdr-hpsdr.org/
>
> No virus found in this incoming message.
> Checked by AVG - http://www.avg.com
> Version: 8.0.138 / Virus Database: 270.6.7/1629 - Release Date: 8/23/2008 
> 1:16 PM
>
>
> 


 1219757957.0