[hpsdr] Mercury - Placement on Atlas Bus

[Philip Covington]

On Tue, Dec 23, 2008 at 7:20 AM, Gerd Loch <g.loch at nt-electronics.de> wrote:
> ***** High Performance Software Defined Radio Discussion List *****

> I know the measurements but I asked which layer stackup was used for the
> tested Atlas board because impedance is dependent on it. I did not receive
> an answer to this question.

The TDR and VNA measurements in the ATLAS document should tell you
what you need to know.  Based on the layer stack up and information
from the PCB manufacturer, the actual impedance measurements were
lower than what the stack up and materials info would predict.

73 Phil N8VB

 1230036991.0