[hpsdr] PTT and CW with Penelope

Willi Reppel wi.re at telia.com
Sun Jun 21 10:25:19 PDT 2009


Hi Roger,

For using cw mode, I have connected my keyer to pins 5,6 and 7 of the DB-9 
connector of Ozy as described in Janus & Ozy manual, page 10. To switch from 
receive to transmit in cw mode, you should connect pin 1 of the  DB-25 
connector of Penny to ground if you like to use a foot switch or other type 
of rx/tx switch. Try this for a difference and see if it solves your 
problem.

Best 73
SM6OMH  Willi
----- Original Message ----- 
From: "Roger Rehr" <73w3sz at gmail.com>
To: <hpsdr at lists.openhpsdr.org>
Sent: Sunday, June 21, 2009 6:36 PM
Subject: [hpsdr] PTT and CW with Penelope


> ***** High Performance Software Defined Radio Discussion List *****
>
> Hi All,
>
> I have several HPSDRs [Ozy/Penelope/Mercury] running, and am using 
> versions of software/firmware from early to recent.  With each one, I 
> have an annoying anomaly with PTT that I do NOT see with PowerSDR 1.16 
> and my Flex5000 or with WU2X PowerSDR/K3 IF Stage v0.92 and my K3.
>
> Specifically, with the Penny/Merge PowerSDR 12Apr2009 or 10Jun2009 and 
> with Firmware either:
> Ozy 20090201
> Ozy 12
> Mercury 26
> Penelope 11
>
> or
>
> Ozy 20090524
> Ozy 14
> Mercury 27
> Penelope 12
>
> when I activate PTT via the 3.5 mm stereo connector on Penelope when  in 
> CW mode, it causes Penelope to go to key down condition and send CW 
> carrier.  This is not as it should be, and not as it is with the other 
> non-HPSDR PowerSDR systems noted above.  What should happen when PTT  is 
> activated is that Penelope should go to transmit mode, but not send  a 
> carrier until the CW key is closed.
>
> If I activate transmit mode by clicking on the MOX button this problem 
> does not occur.
>
> I have tried various combinations of PowerSDR settings with no success  in 
> correcting this misbehavior [including messing with:
> disable PTT
> All Mode Mic PTT
> Break in Enabled].
>
> PTT works as it should in voice modes.
>
> I do have ring and mic jumpers set properly on Penelope [PTT to ring  and 
> MIC to tip in my case].
>
> Anyone else observe this?
>
> What is the cure?
>
> Thanks in advance,
>
> Roger Rehr
> W3SZ
>
>
> _______________________________________________
> HPSDR Discussion List
> To post msg: hpsdr at openhpsdr.org
> Subscription help: 
> http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
> HPSDR web page: http://openhpsdr.org
> Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/
> 


 1245605119.0


More information about the Hpsdr mailing list