[hpsdr] programming Penny

[Phil Harman]

Ken,

You need to set the Cyclone II configuration jumpers since you are not 
able to load code into the FPGA that enables it to program its flash 
memory.

See the Penny user guide on the Wiki for the jumper settings.

73's Phil...VK6APH




Quoting Ken <ke2n at cs.com>:

> Now having read the instructions, I am reminded that I need the JIC 
> and CDF files for Penny.
>
> When I run the batch file, the first part, invoving OZY runs as with Mercury
> then I get an error message - here is the text from Quartus
>
> Info: Command: quartus_pgm -c USB-Blaster Penelope_V1.1.cdf
> Info: Using programming cable "USB-Blaster [USB-0]"
> Info: Started Programmer operation at Tue Mar 10 22:53:15 2009
> Info: Configuring device index 1
> Info: Device 1 contains JTAG ID code 0x020B20DD
> Info: Configuration succeeded -- 1 device(s) configured
> Error: Flash Loader IP not loaded on device 1
> Error: Operation failed
> Info: Ended Programmer operation at Tue Mar 10 22:53:18 2009
> Error: Quartus II Programmer was unsuccessful. 2 errors, 0 warnings
>    Error: Peak virtual memory: 55 megabytes
>    Error: Processing ended: Tue Mar 10 22:53:18 2009
>    Error: Elapsed time: 00:00:04
>    Error: Total CPU time (on all processors): 00:00:01
> Press any key to continue . . .
>
> Any help please?  Sounds like the Penny board is not "talking"?
> NOTE: I have not put jumpers on any of the configuration headers 
> other than the JTAG
>
> Thanks
>
> Ken
> KE2N
>
>



----------------------------------------------------------------
This message was sent using IMP, the Internet Messaging Program.


 1236730367.0