[hpsdr] Mercury JTAG programming error - help!

[Bill Tracey]

Marco,

Can you point me to the instructions you're following?  At what point 
in the process do you get this error?  Are there any errors earlier 
in the process?

Regards,

Bill  (kd5tfd)

At 03:36 PM 10/8/2009, Marco IK1ODO wrote:
>***** High Performance Software Defined Radio Discussion List *****
>
>
>I know that it has been discussed before, but... help!
>
>I'm setting up my HPSDR - Ozy and Mercury to begin with.
>All boards were tested with a friend months ago, and all was ok.
>Now I'm following the instructions in the quick startup guide to 
>update firmware, and I'm stuck with
>Error: Can't access JTAG chain
>Error: Operation failed
>
>Ozy in slot J5, Mercury in J6, JP7 jumper duly placed. Power supply 
>seems fine. All software just loaded, all (presumably) up to the last versions.
>
>Tried two times, rebooted, etc. - now what? :-\
>
>Marco IK1ODO



 1255061190.0