[hpsdr] Operating Penelope without load

[Phil Harman]

Hi Isaac,

That should be fine. You could also remove the jumper on JP2 or JP3 so you 
don't drive the PA stage.

73 Phil...VK6APH


----- Original Message ----- 
From: "Isaac Weksler" <iweksler at bezeqint.net>
To: <hpsdr at lists.openhpsdr.org>
Sent: Monday, April 25, 2011 2:42 PM
Subject: Re: [hpsdr] Operating Penelope without load


> ***** High Performance Software Defined Radio Discussion List *****
>
> Hi, all.
>
> Is it safe for Penelope to operate it without load? I need the controls it
> provides but would like to use the input to antenna switch for an
> independent transmitter. The transmit power is set to 0.
>
> 73 Isaac 4Z1AO
> _______________________________________________
> HPSDR Discussion List
> To post msg: hpsdr at openhpsdr.org
> Subscription help:
> http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
> HPSDR web page: http://openhpsdr.org
> Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/
>
> _______________________________________________
> HPSDR Discussion List
> To post msg: hpsdr at openhpsdr.org
> Subscription help: 
> http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
> HPSDR web page: http://openhpsdr.org
> Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/
>
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 10.0.1321 / Virus Database: 1500/3595 - Release Date: 04/24/11
> 


 1303718161.0