[hpsdr] Metis quit working
Joe Martin K5SO
k5so at valornet.com
Tue Apr 26 18:19:39 PDT 2011
Hi Phil,
Okay, thanks, I'll remember that.
However, earlier with my Metis board failure that was not possible; an
EEPROM reload using a blaster cable was the only way to recover from
that one.
73, Joe K5SO
On Apr 26, 2011, at 6:37 PM, Phil Harman wrote:
> Hi Joe,
>
> You wrote:
>
>> If NONE of the status LEDs are
>> lit (as happened to me and a few others now) then the programming in
>> the EPROM has become corrupted or erased and it will be necessary for
>> you to re-program the EPROM on Metis with a blaster cable in order to
>> recover.
>>
>
> If the Metis code in the EEPROM has accidently been erased then before
> re-programming put the board in Bootloader mode. The part of the
> EEPROM
> that holds the Bootloader code is not accessible from the Metis code
> so
> its quite likely that you can still run the Bootloader and use it to
> recover the Metis code.
>
> 73 Phil...VK6APH
>
1303867179.0
More information about the Hpsdr
mailing list