[hpsdr] Latest FPGA code

[Dave Larsen]

Dave--

On my Linux ghpsdr3 code from the SVN
Mercury_V3.1
Metis_V1.6

with this firmware and only the two board in the atlas:

Receiver 0 works fine
receiver 1-3 produce output, no real signals just a spike at the center 
frequency that stays on the center frequency as you tune.

I take it that we have a difference between what W1BW's multireceiver 
FPGA code sent out and what the new FPGA code now sends out.

This behavior is the same using either jmonitor or QtRadio

I will step back to the older code to confirm it is working.

I was wondering if I am missing something relative to your setup.

Dave , KV0S



On 11/13/2011 10:32 AM, David McQuate wrote:
> ***** High Performance Software Defined Radio Discussion List *****
>
>
>
> Problems with new fpga code with > 1 receiver on one Mercury ???
>
> Using ghpsdr3-Windows (new version that works with Ozy or Metis),
> whenever # receivers is > 1 AND Penelope is on Atlas bus,
> the 3 Sync bytes are not found.  This happens only using Metis, not Ozy.
>
> (All is fine with up to 4 simultaneous receivers on on Mercury if
> Penelope is NOT connected to Atlas.
>
> I'm using
> Mercury_V3.1
> Penelope_V1.6
> Metis_V1.6
> Ozy_Janus_V2.1
>
> 73,
> Dave
> wa8ywq
>
>
>
> _______________________________________________
> HPSDR Discussion List
> To post msg: hpsdr at openhpsdr.org
> Subscription help: http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
> HPSDR web page: http://openhpsdr.org
> Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/


-- 
Dave KV*?*S
kv0s.dave at gmail.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/attachments/20111113/d2696f58/attachment-0004.htm>