[hpsdr] Hermes check out

[Jeremy McDermond]

On Apr 5, 2012, at 4:43 PM, Lyle Johnson wrote:

> ***** High Performance Software Defined Radio Discussion List *****
> 
> I think you can leave off the plastic bezels and just screw the aluminum end plates tot he extrusion.  The bezels space the end plates off the extrusion a bit at each end.

You're right that the plastic bezels space the end plates off of the end a ways, Lyle.  It fits a lot better without them in place:

https://picasaweb.google.com/lh/photo/LLMdPiuY9O7bkH_z7O4PuNMTjNZETYmyPJy0liipFm0?feat=directlink
https://picasaweb.google.com/lh/photo/Tdj6Jy7iY9oQF0UZ4jfVn9MTjNZETYmyPJy0liipFm0?feat=directlink

But I'm not sure that it looks quite as good without the bezels in place.

> Lyle KK7P
> 
>> The other big issue with this setup is that Hermes is slightly too short for a good fit in the case.

--
Jeremy McDermond (NH6Z)
Xenotropic Systems
mcdermj at xenotropic.com




 1333670634.0