[hpsdr] Hermes check out

[John Koster]

When you're dealing with RF, metal to metal probably trumps looks anyhow.  

On Thu, 5 Apr 2012, Jeremy McDermond wrote:

> ***** High Performance Software Defined Radio Discussion List *****
> 
> On Apr 5, 2012, at 4:43 PM, Lyle Johnson wrote:
> 
> > ***** High Performance Software Defined Radio Discussion List *****
> > 
> > I think you can leave off the plastic bezels and just screw the aluminum end plates tot he extrusion.  The bezels space the end plates off the extrusion a bit at each end.
> 
> You're right that the plastic bezels space the end plates off of the end a ways, Lyle.  It fits a lot better without them in place:
> 
> https://picasaweb.google.com/lh/photo/LLMdPiuY9O7bkH_z7O4PuNMTjNZETYmyPJy0liipFm0?feat=directlink
> https://picasaweb.google.com/lh/photo/Tdj6Jy7iY9oQF0UZ4jfVn9MTjNZETYmyPJy0liipFm0?feat=directlink
> 
> But I'm not sure that it looks quite as good without the bezels in place.
> 
> > Lyle KK7P
> > 
> >> The other big issue with this setup is that Hermes is slightly too short for a good fit in the case.
> 
> --
> Jeremy McDermond (NH6Z)
> Xenotropic Systems
> mcdermj at xenotropic.com
> 
> 
> 
> _______________________________________________
> HPSDR Discussion List
> To post msg: hpsdr at openhpsdr.org
> Subscription help: http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
> HPSDR web page: http://openhpsdr.org
> Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/
> 

-- 
73,
John, W9DDD

Sent from my Linux PC


 1333679703.0