[hpsdr] Card slot order

[David McQuate]

I've run with cards in various orders without noticing any difference.
The only time order is important is when you're updating board firmware 
using Ozy or Metis as an programmer--that is, when using the 
HPSDRProgrammer software.

Dave
wa8ywq

On 7/19/2012 8:00 PM, Tim O'Rourke wrote:
> ***** High Performance Software Defined Radio Discussion List *****
>
> I am re-configuring Pandora to install Alex boards (yep real slow here!)
> I would like to spread boards out a bit to help with cable management.
> I know earl on there were issues with board placement, not sure if this is still critical.
> Here is what I would like to do:
> J1 Ozy (farthest from power supply)
> J2
> J3 Penny
> J4
> J5 Mercury
> J6 Excalibur
>
> Anyone one else running boards spread out?
>
> Tim W4YN
>
> Tim O'Rourke
> W4YN at ARRL.Net
> Low Power Amateur Radio Rocks
> Member of Flying Pigs,ARCI,GQRP,RSGB,ARRL Life Member
> NHRA Life Member
> _______________________________________________
> HPSDR Discussion List
> To post msg: hpsdr at openhpsdr.org
> Subscription help: http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
> HPSDR web page: http://openhpsdr.org
> Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/
>
>


 1342761871.0