[hpsdr] Programming fixed IP address in Hermes

[John Sager]

Mine works OK, at least to the extent of being able to read both the
IP address (255.255.255.255 on mine) and the MAC address. I haven't
tried changing them as I don't want to at the moment.

With J12 in place, Hermes doesn't recognise IP packets so discovery
won't work. A Wireshark capture of the transactions with J12 in place
shows Hermes receives raw Ethernet frames to the multicast address
11:22:33:44:55:66 and responds with a reply from the same address.

Note that you do have to run HPSDRProgrammer with Administrator
privileges on Windows, or with root privileges on Linux so that
the application can write and receive raw Ethernet frames.

73 John G8ONH

On 24/11/12 12:37, H.A.Meijer wrote:
> ***** High Performance Software Defined Radio Discussion List *****
> 
> 
> 
> Hi,
> 
> I made the same observation with my Hermes board, it did not want to switch
> to the boot loader mode with J12.
> To solve this I had to program the boot loader software to the eeprom with a
> usb-blaster programmer using  quartus II.
> It seems that someone forgot to program the bootloader to the eeprom at
> production.
> 
> Bert PA2XHF
> 
> 
> Op 24-11-2012 4:04, kb3omm schreef:
>> ***** High Performance Software Defined Radio Discussion List *****
>>
>>
>>
>> Attempting to program a fixed IP address into Hermes. Following
>> instructions in Appendix A of Hermes Users Manual v1.9. but programmer
>> does not discover Hermes.
>>
>> Using PC with two NICs and a straight Ethernet cable to interconnect.
>>
>> PowerSDR and cuSDR discover and work fine.
>>
>> Tried once with J12 off, and Programmer did discover, but could not do
>> anything of course, as Hermes not in boot loader mode.
>>
>> Is it possible that the Ethernet cable needs to be a crossover for the
>> boot loader mode to work?
>>
>> 73, Kevin kb3omm
>>
>>

 1353767659.0