[hpsdr] Hermes Troublshooting Help

[Joe Martin K5SO]

Dave, 

Sorry, I mis-spoke.  The file you would load is Hermes.pof (not .rbf) using a blaster cable. 

73,  Joe K5SO

On Oct 30, 2012, at 6:31 PM, Joe Martin K5SO wrote:

> ***** High Performance Software Defined Radio Discussion List *****
> 
> Dave, 
> 
> You can load the Hermes.rbf code directly (and easily) by using a blaster cable (or clone) onto P2, running the Quartus II Programmer utility in "Active Programming" mode.  If you have a blaster cable and are not familiar with using it I can help guide you through it step by step, it could turn out to be your preferred method for updating the firmware.
> 
> 73,  Joe K5SO
> 
> On Oct 30, 2012, at 6:21 PM, Dave Watson wrote:
> 
>> ***** High Performance Software Defined Radio Discussion List *****
>> 
>> :-(
>>  
>> While setting up the bread board to toggle the PennyWhistle and then the Juma amplifiers, it looks like I sent  12V to J11 and popped a hole in Q2. All diodes except D23, D25-D28 went off. No sign of any connectivity to the network on the switch. I ordered a replacement 2N7002K for Q2 from DigiKey yesterday but I don't think that alone would knock out the TCP/IP connectivity and the status diodes . Looking for troubleshooting kick start. I've been taking voltage measurements on the board from the schematics but got to thinking there may be some firmware I zapped which needs reloading through a method not accessible when the TCP/IP route is blocked. I've done a complete inspection of the top and the bottom of the board and this is the only sign of visible damage.
>>  
>> Thanks in advance for any advice,
>> Dave (W4DJW)
>>  
>> :-(
> 
> _______________________________________________
> HPSDR Discussion List
> To post msg: hpsdr at openhpsdr.org
> Subscription help: http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
> HPSDR web page: http://openhpsdr.org
> Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/attachments/20121030/cfcdf79a/attachment-0004.htm>