[hpsdr] Munin - minimum drive to achieve 100W output

[Kjell Karlsen]

Hi Dale.

I think you can leave the transformer as it is if you are going to use it  
on frequencies below 30 MHz. My gain settings are around 50 dB for all  
bands except 6 meter where it is around 45 dB. As the maximum gain is 38,8  
dB, still 6 dB left.

When I am back in normal life after a very fine Arctic summer, I plan to  
make at least 2 Munin PA´s. Then I´ll try to publish data and measurements  
on the Munin 2 web side.

73, Kjell



På Mon, 26 Aug 2013 00:48:47 +0200, skrev dmb at lightstream.net  
<dmb at lightstream.net>:

> ***** High Performance Software Defined Radio Discussion List *****
>
> What is the minimum drive power required by Munin to achieve 100W output?
> My Penelope board has T2 mounted backwards, and I think getting I'm
> dangerously close to damaging the board trying to desolder it in order to
> turn it 180 degrees. If 250 mW is enough to drive Munin close to full
> output, I'll just leave the transformer as-is.
>
> Is there a spec somewhere? I see a lot of documents related to assembly  
> at
> < http://k9ivb.net/munin2/ > but haven't see any spec's by which I could
> determine minimum drive requirements.
>
> Thanks & 73
> Dale, WA8SRA
>
> _______________________________________________
> HPSDR Discussion List
> To post msg: hpsdr at openhpsdr.org
> Subscription help:  
> http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
> HPSDR web page: http://openhpsdr.org
> Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/
>
>


-- 
Sendt med Operas revolusjonerende e-postprogram: http://www.opera.com/mail/

 1377540684.0