[hpsdr] Mounting Munin T1 & T2??

[John]

Transistors T1 and T2 in my Munin kit are made with the two thin 
leads a considerable distance above the top of the mounting 
flange.  When the four corners of the circuit board are spaced so 
that the two thin transistor leads are flat against the pads on top 
of the board, there is considerable distance between the bottom of 
the copper straps and the top of the transistor flange.  As 
transistor hardware is tightened the board starts to bend and the 
transistor leads lift above the pads on the circuit board.

Has anyone else had this problem and, if so, how did you make it work?

Best regards,

John,  WoGN