[hpsdr] Mounting Munin T1 & T2??

[Robert Lorenzini]

On 12/24/2013 11:25 AM, John wrote:
> ***** High Performance Software Defined Radio Discussion List *****
>
>
>
> Transistors T1 and T2 in my Munin kit are made with the two thin leads 
> a considerable distance above the top of the mounting flange.  When 
> the four corners of the circuit board are spaced so that the two thin 
> transistor leads are flat against the pads on top of the board, there 
> is considerable distance between the bottom of the copper straps and 
> the top of the transistor flange. As transistor hardware is tightened 
> the board starts to bend and the transistor leads lift above the pads 
> on the circuit board.
>
> Has anyone else had this problem and, if so, how did you make it work?

Your going to need to make custom spacers.

http://k9ivb.net/munin2/Mounting_The_RD100HHF1.pdf

Bob - wd6dod

 1387913714.0