[hpsdr] Munin L3 link

[Kjell Karlsen]

Hi John.

There is no need to use a Teflon insulated wire for the feedback loop,  
even a bare wire may be used. Just see too that it is not in contact with  
the wires on L3.

73, Kjell




På Wed, 11 Dec 2013 21:21:42 +0100, skrev John <radio at mediacombb.net>:

> ***** High Performance Software Defined Radio Discussion List *****
>
>
>
> Am I correct in using #18 AWG solid wire for the L3 one turn link?
>
> I am asking because some of the photos look as if the Teflon insulated  
> wire used in L4 was also used for the L3 link.  If that is the case, the  
> #18 AWG stranded wire supplied with the kit does not fit through in the  
> holes in the circuit board.
>
> 73,
>
> John,  WoGN
>
> _______________________________________________
> HPSDR Discussion List
> To post msg: hpsdr at openhpsdr.org
> Subscription help:  
> http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
> HPSDR web page: http://openhpsdr.org
> Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/
>
>


-- 
Sendt med Operas e-postklient: http://www.opera.com/mail/

 1386795735.0