[hpsdr] Mercury Level Calibration

[Ken N9VV]

Hi Dan,
are you using DOUBLE SIDEBAND (DSB) with a wide filter that can actually 
find your 7.040 signal? I have successfully used my XG-1
to calibrate the Rx in my Hermes (ANAN-10) Transceiver. At first I had 
the warning message, but once I was setup up properly, it worked 
perfectly. I believe the instructions were in the FLEX-5000 manual.

GL de Ken N9VV

On 7/18/2013 11:17 AM, Dan Mitchell wrote:
> ***** High Performance Software Defined Radio Discussion List *****
>
>
>
> Is anyone besides me having trouble calibrating the level of Mercury? I
> am using the latest PowerSDR and an Elecraft XG-1 to calibrate. PowerSDR
> reports that "(the) Peak is less than 30dB from the noise floor", and,
> that is not really the case here.
> 73,
> Dan, W0IQ
>
>
> _______________________________________________
> HPSDR Discussion List
> To post msg: hpsdr at openhpsdr.org
> Subscription help: http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
> HPSDR web page: http://openhpsdr.org
> Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/
>

 1374164956.0