[hpsdr] Programmer and bootloader under Ubuntu 12.10

[Phil Harman]

Andy,

In which case you just need HPSDRProgrammer V2.0 from the Downloads page
and install WinPcap and you should be good to go.

(NOTE: WinPcap is still required even though it not needed by the code -
the next version of the code will remove this requirement.)

73 Phil...VK6APH


> Phil,
>
> 	The only thing I soldered was the power supply and the backplane. My
> system consists of:
>
> Alex
> Metis Rev A2
> Pennylane Rev B
> Mercury Rev A
> Pandora
> LPU
> Atlas
>
> Thanks.
>
> 73 Andy - KF5JLJ
>
>
> On 03/25/2013 12:38 AM, Phil Harman wrote:
>> Hi Andy,
>>
>> If by built you mean assembled your bare PCB then you are going to need
>> a
>> USB Blaster and Quartus software to load the Bootloader.pof file into
>> the
>> flash memory on Hermes.
>>
>> You can only use the programmer software once the bootloader has been
>> installed.
>>
>> 73 Phil...VK6APH
>>
>>
>>
>>
>>> ***** High Performance Software Defined Radio Discussion List *****
>>>
>>> Hello,
>>>
>>> 	I finally assembled my radio. Its been on my to-do list well over a
>>> year.
>>> I think the
>>> next step is to upload the firmware. I downloaded the firmware and the
>>> programmer.
>>> Unfortunately the programmer won't run. It needs Qt5. I've upgraded
>>> that,
>>> but now it can't
>>> find:
>>>
>>> 	libicui18n.so.49 => not found
>>> 	libicuuc.so.49 => not found
>>>
>>> I can't find those. I grabbed the source from SVN, but can't figure out
>>> how to build it.
>>> There are no make files, scripts etc. Is there some QT magic I need to
>>> invoke?
>>>
>>> Any hints on how to build it?
>>>
>>> Thanks,
>>>
>>> 	Andy - KF5JLJ
>>>
>>>
>>> _______________________________________________
>>> HPSDR Discussion List
>>> To post msg: hpsdr at openhpsdr.org
>>> Subscription help:
>>> http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
>>> HPSDR web page: http://openhpsdr.org
>>> Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/
>>>
>>>
>>
>>
>
>
>



 1364191604.0