[hpsdr] setting metis IP address in PowerSDR

[Andy Howell]

Jeremy,

	Well thats a heck of a note. Window in a virtual machine is pretty much a non-starter
then. I'm really more interested in a linux solution anyway. I though powerSDR would be a
quick way to see if the radio was working.

Under linux I should able to tunnel without to much pain, I think.

Is it UDP based?

Thanks,

	Andy


On 03/26/2013 02:17 AM, Jeremy McDermond wrote:
> You cannot use Metis on different subnets.  It must be on the same L2 segment as the
> computer driving it.  It's a firmware limitation, so unless you intend to do proxy-arp
> tricks or something else equally creative, it won't work.
> 
> On Mar 26, 2013, at 12:11 AM, Andy Howell <andy at gamubaru.com> wrote:
> 
>> ***** High Performance Software Defined Radio Discussion List *****
>> 
>> I'm trying to get PowerSDR working. I can't figure out how to set the IP address of
>> metis. I can ping the metis card.
>> 
>> Setup shows an auto-discover option, but that won't work because I'm on different
>> subnets.
>> 
>> Surely there must be a dialog somewhere that I'm just not seeing.
>> 
>> Thanks,  Andy
> 
> 
> -- Jeremy McDermond (NH6Z) Xenotropic Systems mcdermj at xenotropic.com
> 
> 
> 


 1364284031.0