[hpsdr] external 10MHz reference input

[Chris Wilson]

> ***** High Performance Software Defined Radio Discussion List *****

> Hi Bert, 

> RR, understood.  

> Here I use a TAPR TADD distribution amp between my Rb-vapor freq
> standard output and the ext 10 MHz input on my radios.  Perhaps you
> need a bit more in terms of drive for the ext 10 MHz input on your Hermes boards?

> Keep in mind the 3.3v limit on the board devices, as has been mentioned.

> Good luck! 

> 73,  Joe K5SO



18/05/2013 22:12

Hi Joe, can you tell me if these distribution amps are still
available? I am now at a point where I have more test gear and stuff
than I can realistically daisy chain from my Trimble Thunderbolt GPS
locked source without a distribution amp. I seem to recall seeing this
was discontinued, but not sure. Thanks!

-- 
       Best Regards,
                   Chris Wilson.


 1368911639.0